3
votes
NIC transmission is serial or parallel
The reason many people gloss over this stuff is because if you actually look at the real details and not oversimplified models it's a massive rabbit hole.
Firstly Ethernet is not just one type of ...
- 13.1k
2
votes
Router System Capacity Vs Packet Forwarding Capacity
We cannot know for sure what Juniper refers to when stating "system capacity 80gps"
If we take the embedded 4 x 10G interface and we use them at full duplex then we get 80gbps. So it could refer to ...
- 19.5k
2
votes
Accepted
NIC transmission is serial or parallel
If you think about it you already know the answer. To spur you along it is easier to think of optical cabling than copper to think through the example. With optical cabling there is one core for Tx, ...
- 299
2
votes
Turning Off SPC card on Juniper SRX5800 series Firewall
That would appear to be the case. Juniper's documentation only shows a full chassis shutdown when messing with an SPC. (shutdown and power off the standby unit.)
- 31.7k
2
votes
Cisco catalyst 45xx series compatibility with RG45 10Gb
I know that with the WS-C4507R+E supervisor, you can use the WS-X4712-SFP+E Catalyst 4500 E-Series 12-Port 10GbE (SFP+) line card. The SFP+ slots can use either 1 Gb SFP or 10 Gb SFP+ transceivers.
...
- 98.7k
1
vote
Cisco catalyst 45xx series compatibility with RG45 10Gb
From a quick glance at this data sheet, table 1 seem to indicate that your chassis and SUP support all line cards except the 24Gbps 47xx series.
So I may have missed one or two but it seems all these ...
- 2,638
Only top scored, non community-wiki answers of a minimum length are eligible