Skip to main content
1 vote

Using a switch and a pc to test the ports of another switch that resides in a device I wish to test

I need to verify the operation and signal integrity of the ports on the Device. You can verify operation with a simple software test but you can't verify (analog) signal integrity without special ...
Zac67's user avatar
  • 85.4k
1 vote

Iperf testing- Slow transfer speeds

In my experience Azure throttle the traffic and you can only achieve limited performance on a single flow. This is because aside the public access they sell the express route circuit. If you could ...
JFL's user avatar
  • 19.7k
1 vote

IPerf test| Server side Sender data shows that the bandwidth is zero but Client has bandwidth of 125 Mbps

With iPerf3 [1], looking at, respectively working from the responder or "server" side (running iperf3 -s) is of lesser interest. You can gain as much, or even more information from the ...
Marc 'netztier' Luethi's user avatar
1 vote
Accepted

Cat5 Ethernet cable between buildings passes connectivity test but switch light not lighting up and no connectivity

Very often when a cable suddenly fails, the termination isn't good enough. Double check each side's termination, and if that doesn't help replace the cable. If you haven't done so, make sure no small ...
Zac67's user avatar
  • 85.4k

Only top scored, non community-wiki answers of a minimum length are eligible