Trojan
  • Member for 7 years, 11 months
  • Last seen more than 3 years ago
  • Chennai, India
At which OSI Layer does RIP work?
1 votes

Ripv2 & RIPng are layer 3 protocols and these protocols generate and multicast(224.0.0.9) updates every 30 seconds by default. These update packets are carried by the transport layer protocol UDP ...

View answer
About the switchport mode
0 votes

switchport mode access - This command puts the interface (access port) into permanent nontrunking mode. The interface will generate DTP frames, negotiating with the neighboring interface to convert ...

View answer
OSPF manual neighbor configuration requirement on NBMA network
0 votes

This network type is used on networks that have no broadcast/multicast capability, such as frame-relay, ATM, SMDS, & X.25. The key point is that these layer 2 protocols are unable to send ...

View answer
CPU Impact of "debug ip packet" on Cisco Switches
0 votes

Use the debug ip packet command to monitor packets that are processed by the routers routing engine and are not fast switched. This command generates an output for every single packet, therefore it ...

View answer
What is the "technical" definition of LAN and WAN
0 votes

LAN: Single LAN for Eg: group of device like pc,printer.. connected to switch i.e Single LAN. Ethernet is by far the most commonly used LAN technology if u want to create multiple lan in single ...

View answer