RussellM
  • Member for 7 years, 5 months
  • Last seen more than a month ago
  • Brisbane, Australia
Reason for an Access <-> Trunk Uplink between switches
3 votes

Generally that is a bad configuration. Perhaps someone just tried different things until something worked. The other option was that they wanted to use the switch with the VLAN 10 access port as ...

View answer
Switching and MAC Address representation?
2 votes

To answer the first part of your question: The MAC address doesn't change on frames within a LAN, only after passing through an L3 gateway/router where they could be changing Ethernet LAN/ broadcast ...

View answer
Cisco 2960-X IP Address
Accepted answer
2 votes

Based on what you are trying to do, I would suggest not trying to add multiple IP interfaces on your L2 switch, but rather configure your router so you can route from the server VLAN to VLAN 1 and ...

View answer
What network topology should I use to monitor traffic?
1 votes

Since you do have SNMP you could use any number of SNMP capable NMS. These however will give you per port statistics. If you want total traffic you could look at Netflow, again several tools are ...

View answer
Two different FS transceivers on point to point link
0 votes

What you have isn't right, it may actually link up, but I wouldn't recommend it. For short distance (less than 300m) inside data center over Multimode optical fiber (MMOF) 10GBASE-SR is what you want....

View answer
How to push same configuration lines on to all the routers and switches using any script/tool?
0 votes

What you want to do is pretty straight forward and there are plenty of good options out there to update the config on multiple devices. However in your situation this is complicated by having to ...

View answer