Timeline for Unable to use a specific IP for an IP Camera attached to a Cisco 2960 static access port
Current License: CC BY-SA 4.0
14 events
| when toggle format | what | by | license | comment | |
|---|---|---|---|---|---|
| Jun 10, 2020 at 19:45 | vote | accept | Rob Gates | ||
| Jun 9, 2020 at 17:57 | answer | added | Rob Gates | timeline score: 0 | |
| Jun 9, 2020 at 14:12 | comment | added | Ron Maupin♦ |
One thing I noticed is that your SVIs on the switches are messed up. You should only have an IP address on the management VLAN SVI (apparently VLAN 1), and the ip default-gateway address should be the router address for the management VLAN (apparently the SVI address for switch 1), not the switch SVI address. Switch 1 has IP routing enabled, so it should not have a default gateway because it is the default gateway, so it should have a default route or a routing protocol. You should also have descriptions on, at least, the trunk and port channel interfaces.
|
|
| Jun 9, 2020 at 13:48 | comment | added | Rob Gates | Part of the problem is that I cannot ping the ip except from the switch where it resides. However, I get no reply when I remove the camera. There are no static routing tables nor ARP entries. | |
| Jun 9, 2020 at 13:44 | comment | added | Ron Trunk | If you remove the "correct" camera, can you still ping the IP? Did the arp table change? Check for static ARPs, as @ronmaupin suggests. | |
| Jun 9, 2020 at 13:04 | history | edited | Rob Gates |
edited tags
|
|
| Jun 9, 2020 at 12:58 | comment | added | Rob Gates | Thanks Ron, I cleeared the ARP table on the server. It has the correct IP/MAC in it. I have about 12 switches. All of the switches that are routed through switch 1 to get to the camera switch , cannot ping the ip. I feel like the problems lies on switch 1, but I don't know where to look. Switch1: drive.google.com/file/d/1Zr-XewW2W5mlwqSJasM19MX-WuzFQNQC/… | |
| Jun 8, 2020 at 21:40 | comment | added | Ron Maupin♦ | Is there a permanent ARP table entry with the MAC address of the old camera placed in the server? That could be the problem if the server is trying to contact the old camera. Remember that frames are delivered via MAC address, not IP address. | |
| Jun 8, 2020 at 21:06 | history | edited | Rob Gates | CC BY-SA 4.0 |
added 129 characters in body
|
| Jun 8, 2020 at 20:35 | history | edited | Rob Gates | CC BY-SA 4.0 |
edited title
|
| Jun 8, 2020 at 19:11 | answer | added | Zac67♦ | timeline score: 1 | |
| Jun 8, 2020 at 18:50 | review | First posts | |||
| Jun 8, 2020 at 19:57 | |||||
| Jun 8, 2020 at 18:47 | comment | added | Ron Trunk | You can check the arp table on the subnet gateway to get the MAC address(s) used by that IP. Then you can check the MAC address table on the switches to see which port that MAC is coming from. | |
| Jun 8, 2020 at 18:43 | history | asked | Rob Gates | CC BY-SA 4.0 |