I would like to know the command to configure CLI on cisco equipment to make the cursor move to the new line right away after it showed the message. So for example:

Router#

Router#

00:00:00: Interface Ethernet0 chaged state to up.Link blablalba (cursor is here)*

and then the cursor stays on the same line where the message was displayed..

I want it to move to the next line right away automatically.

Example:

Router#

Router#

00:00:00: Interface Ethernet0 chaged state to up. Line protocol blablalba

Router#(cursor is here)*

Thanks, Paul

I would like to know the command to configure CLI on cisco equipment to make the cursor move to the new line right away after it showed the message. So for example:

Router#
Router#
*00:00:00: Interface Ethernet0 chaged state to up.Link blablalba* ***(cursor is here)**** 

and then the cursor stays on the same line where the message was displayed..

I want it to move to the next line right away automatically.

Example:

Router#
Router#
00:00:00: Interface Ethernet0 chaged state to up. Line protocol blablalba
Router#****(cursor is here)****