How does a GSM network route internet packets? Does GSM use NAT based PAT like a physical Router? For example, user A visits website #1 and user B visits website #2. how data of website #1 are given to user A instead of B or both of them?
Add a comment
|
2 Answers
GSM data networks (GPRS, LTE etc) allocate IP addresses to end devices (Mobile Phones) just like any other network.
As to whether NAT/PAT is used, this is entirely carrier dependent - based on a factor of how big their subscriber base is and how many public IPv4 addresses they have available.
In Australia, the incumbent telco Telstra uses a CGN (carrier-grade NAT) to support the massive numbers of 3G/LTE subscribers currently using it's network. All devices using their default APN are allocated an address from 10.0.0.0/8, and then NATted to the Internet. Public IPs are available, but only on premium services.
In markets where IPv6 is more established (eg: much of Asia), end devices are more likely to be provided with a public v6 address, requiring CGN only where the content being viewed is v4 only.
-
1+1, "As to whether NAT/PAT is used, this is entirely carrier dependent". Commented Oct 23, 2014 at 5:00
-
Afiact very few carriers give out public IPv4 to mobile devices. They either get private v4, dual stack with private v4 and public v6 or v6 only with NAT64. Commented Jan 19, 2017 at 2:18
-
When some of our local (.au) mobile providers mobile data services first launched, they would hand out dynamic public IPv4 to handsets. This practice didn't last all that long ; ) Commented Jan 19, 2017 at 4:25
IMEI is provided by equipment manufacturer for the mobile. It is stored in EIR via the network operator while registration. IMSI is a combination of MCC(Mobile country code), MNC(Mobile Network code) , MSIN(Mobile subscriber Identification number) and is stored in SIM. There are several such identifiers based on the mode of operation to uniquely identify a user.
GSM is a combination of TDMA/FDMA. Each BS is assigned one or more carrier frequencies which is then divided in time, using a TDMA scheme, into 8 time slots. The time slot usage is such that the mobile does not recieve and send it the same time. That is, the MS uses one time slot for transmission and one for reception.
The BSS acts as a radio resource manager and allocates a traffic channel (a radio channel and a time slot) for every MS once authenticated and informed by MSC. Each MS operates only over the provided radio channel in the given time slot.
In GSM, the RR protocol between the MS, BTS and BSC(BSS) does the routing of the data to the recipient and you can consider it to be similar to that of network layer(layer 3 of OSI). The routing of data is further coupled with SCCP for end to end addressing/routing in SS7.
-
This answer would benefit from a diagram and references if possible Commented Oct 23, 2014 at 2:27