Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
2 votes
1 answer
79 views

Cisco snmp-server single user for multiple snmp versions

Attempting to maintain SNMP v2c compatibility while implementing SNMP v3 on cisco switch 5506cx. Would a user that was previously used for v2c see issues with v2c if it is added to a v3 group? For ...
2 votes
1 answer
1k views

How to copy Running Config from a switch using SNMP commands on Cisco ASR1002?

I trying to copy a running config from a cisco switch using the snmp commands on a Cisco ASR1002. On the Cisco ASR I enabled snmp-server manager by using this command: conf t snmp-server ...
5 votes
1 answer
675 views

Enable traps on FIB (Forwarding Table) changes

I've been working for weeks to enable sending traps for FIB changes on our Cisco 2600 router. I finally found this command is responsible for that: snmp-server enable traps cef peer-fib-state-change ...
6 votes
2 answers
4k views

SNMPv3 Setup - Cisco 3750

I am not a network guru by any means but need to setup our router/switch to use SNMPv3. I am installing What's Up Gold on our system and configured the settings (changed for this post) as follows: ...
6 votes
2 answers
4k views

SNMP and Syslog in configuration

Really stupid questions guys so I apologize. When sending Syslog messages to a server we use the command logging x.x.x.x. I get that part. SNMP is used to gather stats or change configurations on ...