8

I would like to know the command to configure CLI on cisco equipment to make the cursor move to the new line right away after it showed the message. So for example:

Router#
Router#
*00:00:00: Interface Ethernet0 chaged state to up.Link blablalba* ***(cursor is here)****

and then the cursor stays on the same line where the message was displayed..

I want it to move to the next line right away automatically.

Example:

Router#
Router#
00:00:00: Interface Ethernet0 chaged state to up. Line protocol blablalba
Router#****(cursor is here)****
Improve this question
2
  • logging synchronous is what you want, as @KellerG and @Ryan have mentioned, but typically having logging sent to the console is undesirable, unless you're doing debugging.
    – John Jensen
    Commented Nov 7, 2013 at 19:20
  • Ctrl-r is worth mentioning to refresh the CLI.
    – generalnetworkerror
    Commented Nov 13, 2013 at 6:03

2 Answers 2

Reset to default
7

I think you're looking for "logging synchronous".

Improve this answer
14

Specifically, you're looking for this:

line con 0
 logging synchronous
line vty 0 15
 logging synchronous
Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.