1

In Juniper, NTP broadcast is set at system level, so two VRFs cannot use the same addressing and use NTP broadcast at the same time. Is there any alternative?

Improve this question
2
  • 1
    Do you have a specific use case that requires NTP in broadcast mode? The best alternative may be to not use ntp broadcast.
    – JFL
    Commented Jul 7, 2020 at 11:11
  • Did any answer help you? If so, you should accept the answer so that the question doesn't keep popping up forever, looking for an answer. Alternatively, you can post and accept your own answer.
    – Ron Maupin ♦
    Commented Dec 17, 2020 at 18:50

1 Answer 1

Reset to default
3

I know that most of the type the same configuration you want in the default instance exists in the same config stanza within routing-instances, in this case it's the other way around.

Addressing shouldn't matter as routing instances are separate routing tables.

You can enable broadcast NTP in a VRF with:

set system ntp broadcast 10.1.0.0 routing-instance-name VRFA
set system ntp broadcast 10.2.0.0 routing-instance-name VRFB
set system ntp broadcast 10.3.0.0 routing-instance-name VRFC
Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.