All Questions
7 questions
1
vote
2
answers
623
views
High-Resolution Measurement of link utilization of Cisco (Nexus) Switch Interfaces
For a research project I need low timescale interface utilization measurement on a Cisco Nexus 5000 devices and some fabric extenders.
Background: The switch is used to "simulate" an optical network, ...
- 1
3
votes
1
answer
54
views
LAN side 1Gb link showing WAN 4Mbps throughput in SNMP
I am a-bit confused here.
I have a FW connected to L2 switch then to an ISP router.
My ISP link has a 4Mb capped on the egress.
[My FW] <-1Gb link-> [p0 L2 Switch p1] <-1Gb link-> [ISP ...
- 539
1
vote
2
answers
2k
views
how can i monitor traffic on particular port in 3650 L3 switch?
I have cisco WS-C3650-48TS SW version 03.03.05SE as L3, i need to monitor the traffic on a trunk port?
How much bandwidth its consuming?
CommunityBot
- 1
1
vote
1
answer
791
views
SNMP bandwidth and response time
I've been trying to learn about SNMP Protocol (as a beginner)
When studying network performance, we look at three main points:
- Bandwidth
- Response Time
- Devices Availability
But which of these ...
- 461
1
vote
2
answers
316
views
ifHCOutOctets doesn't working with snmpget
How do i get counter64 to monitor hight bandwidth using snmp?
Counter32 works!
spatel@MBP:~$ snmpget -v1 -c public switch.cisco.com ifOutOctets.50
IF-MIB::ifOutOctets.50 = Counter32: 2038072800
...
- 276
1
vote
0
answers
2k
views
Get interface input/output rate statistics over SNMP from Huawei switch
We need to monitor the download/upload bandwidth on interfaces on Huawei S5300 switches, and we need to do it with a specific monitoring system. This system can get information from a switch using ...
- 139
2
votes
1
answer
962
views
Bandwidth Speeds
I have a Cisco Catalyst 6500 with the 720 Supe card. I would like to get the upload and download utilization of a specific port. I would like it from SNMP, I have looked for the correct MIB but no ...
- 463