While plug in a SM-X-ES3D-48-P Etherswitch Module into a Cisco ISR 4451 the Ports for this Module didn't came up. What I need to do to get the Ports enable with sh ip int br command?
The Output of sh hw-module all attribute is:
Slot 0 Bay 0 Board 0 Module[ISR4451-X-4x1GE] spa_type 0x76E Daughter Board Not Present
Basic attributes : length 11, version [2], module-type [ngio-virtual], width [unknown]
Power Rating [0], Control Endpoint count [0], Daughter Board Count [0]
KR Support [0x00], 16-bit GPIO [Not present], Submodule reset support [Not required]
Extended Attributes for [Front Panel 4 ports Gigabitethernet Module]
Port Count 4 Per-port Information : Type [Ethernet] Max IID [0] Connector [RJ45] Network clocking [disable]
Module OID: 1 3 6 1 4 1 9 12 3 1 9 92 21
Port OID: 1 3 6 1 4 1 9 12 3 1 10 109
Slot 1 Bay 0 Board 0 Module[SM-X-ES3D-48-P] spa_type 0xB4B Daughter Board Not Present
Base mac_addr 00da.55b0.e300 mac_blk_sz 128 Endpt MAC Address offset(s) : 52
Basic attributes : length 11, version [2], module-type [alien], width [Double Wide-no aux]
Power Rating [100], Control Endpoint count [1], Daughter Board Count [0]
KR Support [0x00], 16-bit GPIO [Present], Submodule reset support [Required]
Extended Attributes for [SM-X-ES3D-48-P: EtherSwitch SM L3 + PoEPlus + MACSec + 48 10/100/1000 + 2 SFP]
GPIO Pin Information
Output Pin[Sub module reset]
Input Pin[PRI interface ready]
Output Pin[Reset config]
I2C Information
[dev_addr 0xB dev_type quack]
Port Count 2 Per-port Information : Type [Ether-Internal] Max IID [0] Connector [RJ45] Network clocking [disable]
Module OID: 1 3 6 1 4 1 9 12 3 1 9 96 6
Port OID: 1 3 6 1 4 1 9 12 3 1 10 109
In the docu for this module I can't find a way to activate this 48 Ports and sh ip int br Command didn't show the Ports. What can I do?
