User Baldrick

23 votes

When to choose fiber instead of twisted pair (copper)

answered May 8, 2013 at 10:10

18 votes

Accepted

Are there any reasons to not use BFD?

answered May 20, 2013 at 8:36

15 votes

Accepted

Is TCP maximum segment size (MSS) "clamping" compatible with IPv6?

answered May 9, 2013 at 19:35

14 votes

Protocols: EIGRP vs OSPF

answered May 8, 2013 at 19:39

11 votes

Which is the Preferred location of an IPS within a network?

answered May 22, 2013 at 20:01

10 votes

Accepted

Media Transfer rates......is using laser over fiber the fastest?

answered May 23, 2013 at 19:57

10 votes

Accepted

Cisco: Is it possible to see an EFP path within an EVC?

answered Jun 27, 2014 at 10:37

9 votes

How would a router with /32 WAN subnet mask communicate with the rest of the Internet?

answered May 19, 2013 at 20:41

9 votes

Accepted

How can I formulate the communication latency in TCP/IP?

answered May 20, 2013 at 13:08

8 votes

What factors drive a Cisco IOS upgrade?

answered May 30, 2013 at 10:57

7 votes

Accepted

Protocol to push config to Cisco/HP switches?

answered Apr 30, 2014 at 11:44

6 votes

Accepted

EoMPLS, MSTP, and RPVST

answered Apr 27, 2015 at 11:38

6 votes

Better Enterprise Multihoming

answered May 8, 2013 at 21:05

6 votes

Can you reduce RTT by increasing the bandwidth on a link?

answered Jun 15, 2014 at 9:09

6 votes

Accepted

What exactly is the difference between SDN & NFV?

answered Apr 20, 2017 at 8:19

6 votes

Accepted

What advances in hardware allowed DPDK to increase performance on packet processing?

answered Mar 24, 2018 at 18:49

5 votes

Preventing STP loops in etherchannels configurations

answered May 30, 2013 at 11:47

5 votes

interpreting ping results

answered Jul 5, 2013 at 19:13

5 votes

How do I mcast multiple pcap files simultaneously with guaranteed ordering and controllable speed?

answered Jul 10, 2014 at 18:16

4 votes

Using QoS for HTTP

answered Jul 10, 2014 at 19:45

4 votes

Redundant IP link aggregation for failover operation without route failure detection

answered Jul 26, 2013 at 13:40

4 votes

Cisco Catalyst 4500E - modules installation

answered May 23, 2013 at 13:41

4 votes

Is the Slow-Start algorithm responsible for ISP speed throttling?

answered Jun 23, 2015 at 8:59

4 votes

Measuring per-link latency/jitter/packet-loss

answered Jul 11, 2015 at 18:28

3 votes

Accepted

Cisco: Using carrier-delay with BFD on the same interface

answered Jul 1, 2015 at 9:28

3 votes

What is the use case of Automatic protection ring , ERPS, ECFM, UP MEPs or Down MEPs in ISP now?

answered Apr 29, 2017 at 8:40

3 votes

Point to Point Leased Lines - Do they lay fibres just for that purpose?

answered Apr 23, 2016 at 13:33

3 votes

Accepted

Why does starting openvpn client, then dhcpcd give different routing table than the reverse order?

answered Apr 24, 2015 at 22:21

3 votes

Monitor specific traffic type on a Cisco router

answered May 23, 2013 at 12:39

3 votes

What is the difference between all the switching modes on 6500/7600?

answered May 8, 2013 at 16:13

Stack Exchange Network

56 Answers

When to choose fiber instead of twisted pair (copper)

Are there any reasons to not use BFD?

Is TCP maximum segment size (MSS) "clamping" compatible with IPv6?

Protocols: EIGRP vs OSPF

Which is the Preferred location of an IPS within a network?

Media Transfer rates......is using laser over fiber the fastest?

Cisco: Is it possible to see an EFP path within an EVC?

How would a router with /32 WAN subnet mask communicate with the rest of the Internet?

How can I formulate the communication latency in TCP/IP?

What factors drive a Cisco IOS upgrade?

Protocol to push config to Cisco/HP switches?

EoMPLS, MSTP, and RPVST

Better Enterprise Multihoming

Can you reduce RTT by increasing the bandwidth on a link?

What exactly is the difference between SDN & NFV?

What advances in hardware allowed DPDK to increase performance on packet processing?

Preventing STP loops in etherchannels configurations

interpreting ping results

How do I mcast multiple pcap files simultaneously with guaranteed ordering and controllable speed?

Using QoS for HTTP

Redundant IP link aggregation for failover operation without route failure detection

Cisco Catalyst 4500E - modules installation

Is the Slow-Start algorithm responsible for ISP speed throttling?

Measuring per-link latency/jitter/packet-loss

Cisco: Using carrier-delay with BFD on the same interface

What is the use case of Automatic protection ring , ERPS, ECFM, UP MEPs or Down MEPs in ISP now?

Point to Point Leased Lines - Do they lay fibres just for that purpose?

Why does starting openvpn client, then dhcpcd give different routing table than the reverse order?

Monitor specific traffic type on a Cisco router

What is the difference between all the switching modes on 6500/7600?